Zenmuse H3-2D Firmware update v1.6 available

[Fdnyfish]

I received an email from dji support yesterday that said there will be an update to fix this on Friday. So I am guessing a new naza assistant on Friday.

 

[spjlj1]

DJI has fixed the issue! If you are using the Phantom upgrade board, upgrade the Phantom Upgrade Board with the Naza Assistant, recycle, then upgrade the Zenmuse H3-2D using the Naza assistant. Both of these upgrades are located on the Upgrade tab of the assistant. I did this yesterday and everything worked just fine.

 

[SimonB]

DJI has fixed the issue! If you are using the Phantom upgrade board, upgrade the Phantom Upgrade Board with the Naza Assistant, recycle, then upgrade the Zenmuse H3-2D using the Naza assistant. Both of these upgrades are located on the Upgrade tab of the assistant. I did this yesterday and everything worked just fine.

Thanks for this. Is it an upgraded Assustant, I don't see a new one, or any new files for that matter, on DJI's site?

 

[spjlj1]

If you have the Phantom upgrade board (P330CB-H3-2D), here are the instructions on how to upgrade the H3-2D's firmware.
1. Connect the phantom to your computer using the lastest Naza-M assistant. (Naza-M Assistant Software v2.20). Power on the phantom.
2. On the Naza-M assistant, click on the Upgrade tab.
3. You should now see the lastest firmware for the upgrade board (P330CB-H3-2D)
4. Upgrade the P330CB-H3-2D board by clicking on the link.
5. Cycle the power on the Phantom.
6. Connect again to the Phantom with the Naza-M Assistant Software v2.20 application.
6. On the Upgrade tab, you should now see that a firmware upgrade is available for the H3-2D gimbal.
7. Upgrade the H3-2D firmware by clicking on the link.

All done.

 

[diegosamy]

If you have the Phantom upgrade board (P330CB-H3-2D), here are the instructions on how to upgrade the H3-2D's firmware.
1. Connect the phantom to your computer using the lastest Naza-M assistant. (Naza-M Assistant Software v2.20). Power on the phantom.
2. On the Naza-M assistant, click on the Upgrade tab.
3. You should now see the lastest firmware for the upgrade board (P330CB-H3-2D)
4. Upgrade the P330CB-H3-2D board by clicking on the link.
5. Cycle the power on the Phantom.
6. Connect again to the Phantom with the Naza-M Assistant Software v2.20 application.
6. On the Upgrade tab, you should now see that a firmware upgrade is available for the H3-2D gimbal.
7. Upgrade the H3-2D firmware by clicking on the link.

All done.

If we dont have the board and have the pmu v2 we have to upgrage via cgu usb right?

 

[Corben]

I installed everything with the micro USB. I ended up connecting the can-bus before I ran the installer. I'm still having problems getting the tilt to work. Got everything tore apart and trouble shooting now.