Turbo Ace Matrix Bind/Calibration Problems

[tailspin]

Hi all,
I have a Turbo Ace Matrix w/ Naza 2, telemetry, 3 axis gimbal, controlled by DX9. Actually it’s my second. The first one dropped out the air suddenly over Yagul, Oaxaca, MX. I got a replacement aircraft. I had no trouble binding the new unit to the transmitter.

I had it on the shelf for a few months and when I next tried to fly, the aircraft was not bound to the TX. I bound it again and things were fine for a while. Then it started needing binding for every flight, then the TX failed completely. I sent it in for repair in September and brought it back to MX. When I go to bind it I get the audio confirmation “Bind complete.” However, it never actually communicates with the aircraft.

I plug it into the Naza assistant, but there’s nothing.

Here are two videos to show the situation:

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies

I’m still down in Mexico and frankly I feel a bit stranded by the Turbo Ace group. Pretty bad support.

Any ideas would be most appreciated.

Thanks,

Tailspin