- Joined
- Nov 4, 2014
- Messages
- 4
- Reaction score
- 0
Hi all,
Hope somebody has had this problem and might be able to help.
I have the Phantom 2 non-vision with HD3 gimbal and and everything has been working great. On Sunday I was flying on a deserted beach and managed to flip it and it took quite a big fall.
I reconnected the camera and everything looks good. I ran the advanced cali to get mod values back in range - all looks good.
The odd thing is when I go to do the compass calibration the remote control and the Quad are unlinking. The little LED light goes red and the large lights flash a constant yellow. If I power cycle still won't link. I've followed to guidance of pressing the little LED receiver light and turning not he controller but still won't link.
I opened up the top to see if anything was loose but all looked good - checked all the connections and seemed fine. I then did manage to get a relink so thought might have been a dodgy connection.
However after reassembly everything still good. Links is fine.
Then as soon as I try to calibrate the compass is unlinks again. Back to square one.
Any thoughts welcome?
I'm filming in Tanzania so can't try anther controller or pop it back to the supplier who is in DC.
Thanks in advance.
Chris
Hope somebody has had this problem and might be able to help.
I have the Phantom 2 non-vision with HD3 gimbal and and everything has been working great. On Sunday I was flying on a deserted beach and managed to flip it and it took quite a big fall.
I reconnected the camera and everything looks good. I ran the advanced cali to get mod values back in range - all looks good.
The odd thing is when I go to do the compass calibration the remote control and the Quad are unlinking. The little LED light goes red and the large lights flash a constant yellow. If I power cycle still won't link. I've followed to guidance of pressing the little LED receiver light and turning not he controller but still won't link.
I opened up the top to see if anything was loose but all looked good - checked all the connections and seemed fine. I then did manage to get a relink so thought might have been a dodgy connection.
However after reassembly everything still good. Links is fine.
Then as soon as I try to calibrate the compass is unlinks again. Back to square one.
Any thoughts welcome?
I'm filming in Tanzania so can't try anther controller or pop it back to the supplier who is in DC.
Thanks in advance.
Chris