Hello. Iam seeking for help with my P2 vision plus.as on my previous posts ,iam having problems with start up drone.
I will try to say excactly whats happening.
Turning controller and range extender and then battery.lights go on green yellow red, and then on no gps mode ,yellow blinking,on gps mode lights go steady red.sometimes iam able to run calibration,first round goes good,and another round turns to steady red,or flashing red. Sometimes lights going off even battery is on. I did buy this drone as spare /repairs. Guy told me that only two connectors has to be replaced. First 4pin grey connector to gimbal,second is smb lead,and then I realized that base socket is off,so I solder wires to the board,this seems to be ok. I really dont know what else to do. I need good advice what to do next,as heliguy offered check out,but I dont want to put a lot money into this,as I prefer to buy another one working condition. Thanks for reading.
I will try to say excactly whats happening.
Turning controller and range extender and then battery.lights go on green yellow red, and then on no gps mode ,yellow blinking,on gps mode lights go steady red.sometimes iam able to run calibration,first round goes good,and another round turns to steady red,or flashing red. Sometimes lights going off even battery is on. I did buy this drone as spare /repairs. Guy told me that only two connectors has to be replaced. First 4pin grey connector to gimbal,second is smb lead,and then I realized that base socket is off,so I solder wires to the board,this seems to be ok. I really dont know what else to do. I need good advice what to do next,as heliguy offered check out,but I dont want to put a lot money into this,as I prefer to buy another one working condition. Thanks for reading.