Hi,
I have just purchased one of the ebay gimbals. This one http://www.ebay.co.uk/itm/281203609190? ... EBIDX%3AIT
I can't get it to work. Well I sort of had it working. I installed it in to the phantom and then plugged in direct to a 3s lipo. It fired up, lights flashing etc. then levelled up and I could tilt the phantom and the gimbal was self levelling as it's supposed to.
Now I have plugged the servo lead in to the F2 port on Naza. Enabled the gimbal in naza software and the gimbal will not start properly. What's also weird is if I disconnect from Naza and just plug straight to lipo as I first did, the gimbal still will not start properly. It goes to about 45 degrees up and stays there.
Any ideas folks? Thanks.
Cheers, Rich
I have just purchased one of the ebay gimbals. This one http://www.ebay.co.uk/itm/281203609190? ... EBIDX%3AIT
I can't get it to work. Well I sort of had it working. I installed it in to the phantom and then plugged in direct to a 3s lipo. It fired up, lights flashing etc. then levelled up and I could tilt the phantom and the gimbal was self levelling as it's supposed to.
Now I have plugged the servo lead in to the F2 port on Naza. Enabled the gimbal in naza software and the gimbal will not start properly. What's also weird is if I disconnect from Naza and just plug straight to lipo as I first did, the gimbal still will not start properly. It goes to about 45 degrees up and stays there.
Any ideas folks? Thanks.
Cheers, Rich