It finally happened, clipped a branch....
The gimbal broke off below the yaw motor...
Where I am at is after replacing the the yaw motor, arm and ribbon cable, the camera works but the yaw roll are dead.
At power up the pitch motor gos full up and full down then stays there. The Go app is not throwing any warnings, but the gimbal is not operational.
The yaw/roll esc is warm to the touch so I know it has power.
What should I try next?
.
The gimbal broke off below the yaw motor...
Where I am at is after replacing the the yaw motor, arm and ribbon cable, the camera works but the yaw roll are dead.
At power up the pitch motor gos full up and full down then stays there. The Go app is not throwing any warnings, but the gimbal is not operational.
The yaw/roll esc is warm to the touch so I know it has power.
What should I try next?
.
