I'm brand new to drones but tried to figure out as much as I could watching tutorials so I wasnt trying to fly completely blind my first time. That being said. It doesnt seem to respond to commands at higher altitude and by higher I mean higher than 50 feet. It starts slowly drifting up even though my control sticks are centered and I'm no longer touching them. I calibrated the control sticks to make sure they werent a problem. The first couple flights I'm having this same issue and have to tap the left control stick down a few times to get it to respond and start lowering.
Most recently the drone started to drift upward and as usual I tried lowering it by pressing down on the left stick and then releasing and repeating this. Eventually the drone started lowering very rapidly and eventually hit the ground and breaking 2 ends of the landing gear extenders. Luckily I think the drone is OK overall and nothing major broke. I think the gimbal is ok as well.
Finally, the last thing I did was go into flight simulator and I keep getting messages while flying that say "Braking now, return sticks to midpoints, then continue flying". However at this point I'm not even using the controls. So I was wondering if I have an issue with the control sticks. And when I tried calibrating the joysticks when left alone untouched they both read 0% in the middle and both go all the way to 100% in all directions leading me to believe they are fine.
I've attached my last 3 flight logs hoping someone can spot the issue. Anyone that can offer guidance I'd really appreciate it.
Most recently the drone started to drift upward and as usual I tried lowering it by pressing down on the left stick and then releasing and repeating this. Eventually the drone started lowering very rapidly and eventually hit the ground and breaking 2 ends of the landing gear extenders. Luckily I think the drone is OK overall and nothing major broke. I think the gimbal is ok as well.
Finally, the last thing I did was go into flight simulator and I keep getting messages while flying that say "Braking now, return sticks to midpoints, then continue flying". However at this point I'm not even using the controls. So I was wondering if I have an issue with the control sticks. And when I tried calibrating the joysticks when left alone untouched they both read 0% in the middle and both go all the way to 100% in all directions leading me to believe they are fine.
I've attached my last 3 flight logs hoping someone can spot the issue. Anyone that can offer guidance I'd really appreciate it.