Previously I could fly at my local airport (I have direct comms with Airport Director) and the AP is virtually unused. In fact it was my Model Flying area for some time till Govt declared it open 24/7 on permanent 30min standby. It basically sits on the NATO patrol flight path in Baltic.
Go (P3S and P3P) was always a problem but LITCHI had no problem at all ...
Today in response to a request for a test ... I flew 4 batterys with both GO and LITCHI to see if flight was still possible as before.
Setup :
P3P
Nexus 7 vers 2 tablet
FW 1.10.09
GO 3.1.11
Latest LITCHI
As I said - previously there was no limitation with LITCHI ... I could fly inside the airport without problem. GO would not fly of course.
Today both GO and LITCHI refused to enter airport space. Flight in the Restricted Zone was as normal ... GO showing RED MAP and LITCHI plain normal map. But once the boundary was approached - BOTH started to slowly reduce altitude and not enter the airport boundary. I turned heading out and altitude started to climb again.
This is very interesting as the only update I made since last approach to Airport was GO ...
Nigel
Go (P3S and P3P) was always a problem but LITCHI had no problem at all ...
Today in response to a request for a test ... I flew 4 batterys with both GO and LITCHI to see if flight was still possible as before.
Setup :
P3P
Nexus 7 vers 2 tablet
FW 1.10.09
GO 3.1.11
Latest LITCHI
As I said - previously there was no limitation with LITCHI ... I could fly inside the airport without problem. GO would not fly of course.
Today both GO and LITCHI refused to enter airport space. Flight in the Restricted Zone was as normal ... GO showing RED MAP and LITCHI plain normal map. But once the boundary was approached - BOTH started to slowly reduce altitude and not enter the airport boundary. I turned heading out and altitude started to climb again.
This is very interesting as the only update I made since last approach to Airport was GO ...
Nigel
