Welcome to PhantomPilots.com

Sign up for a weekly email of the latest drone news & information

Motors and Futaba Not Communicating?

Discussion in 'Phantom 2 Help' started by catrost, Dec 22, 2013.

  1. catrost

    Joined:
    Dec 22, 2013
    Messages:
    28
    Likes Received:
    0
    Location:
    Daytona Beach, FL
    Hey!
    I had a flyaway yesterday and my Phantom crashed into a palm tree and now it won't fly.

    I've recalibrated it with the Naza software, tested the motors through the software (they all work), tested the Futaba transmitter (it works and is calibrated)...

    But, the transmitter will not arm the motors.

    Any suggestions on fixing this issue?
     
  2. Gizmo3000

    Joined:
    Jan 25, 2013
    Messages:
    1,859
    Likes Received:
    4
    Location:
    Sherman Oaks, CA
    Is the Tx communicating and calibrated from within the NAZA Assistant?
     
  3. catrost

    Joined:
    Dec 22, 2013
    Messages:
    28
    Likes Received:
    0
    Location:
    Daytona Beach, FL

    Yes. After doing everything it still didn't work. Let it sit for a few minutes and all of a sudden (while desperately hoping the motors would start) pulled the sticks to the bottom center, and motors powered on! Recalibrated the Phantom again and she's flying. Not sure what did it, but it's working!
     
Loading...
Similar Threads - Motors Futaba Communicating Forum Date
P2 motors are not starting up using Futaba 14SG Phantom 2 Discussion May 1, 2015
rear motors stop on takeoff Phantom 4 Pro Help Jan 13, 2018
Phantom 3 vibration after removing motors Pro/Adv Discussion Jan 11, 2018
my motors Phantom 4 Pro Help Jan 8, 2018
You were worrying about getting motors wet.... General Discussion Jan 7, 2018