Hi there.
Had a problem today--landed my P2 too hard, about 20 feet away from me and when it landed, it rolled to the side on to the props. Two of the props could not spin, while the other spun fine.
I was low on power and just shut everything down, and finished. This evening when I wanted to take out for one further flight, I noticed my problem. One motor spins normal, no issues. All three of the other motors are not spinning. They move a little in a jarring fashion and slowly, very slowly, spin, but the movement is minuscule, almost non-existent. I try to accelerate the motors, the one that's functioning properly winds up like normal, but no affect on the other 3--they just just move in their little jarring motion.
As I read through the forums, it seems like damaging the motors is hard, and there is not a lot of ways to do so. But these are behaving very strangely and not functioning. I've seen people elude to ESC problems as well.
I'm hoping you might have some suggestions, I can post video of the motor rotation problems for the three not working...
Thanks
Had a problem today--landed my P2 too hard, about 20 feet away from me and when it landed, it rolled to the side on to the props. Two of the props could not spin, while the other spun fine.
I was low on power and just shut everything down, and finished. This evening when I wanted to take out for one further flight, I noticed my problem. One motor spins normal, no issues. All three of the other motors are not spinning. They move a little in a jarring fashion and slowly, very slowly, spin, but the movement is minuscule, almost non-existent. I try to accelerate the motors, the one that's functioning properly winds up like normal, but no affect on the other 3--they just just move in their little jarring motion.
As I read through the forums, it seems like damaging the motors is hard, and there is not a lot of ways to do so. But these are behaving very strangely and not functioning. I've seen people elude to ESC problems as well.
I'm hoping you might have some suggestions, I can post video of the motor rotation problems for the three not working...
Thanks