Motor not working?

[Cubano2031]

How did you change it?

Just unsolder one motor and put the new one but still not working ...i think that the ESC is death


Sent from my iPhone using PhantomPilots mobile app

 

[Squirrel!]

Naa, probably OK...Did you scrape the wire ends BEFORE you attempted to solder them on? If not, likely, that is your problem.

 

[Cubano2031]

Naa, probably OK...Did you scrape the wire ends BEFORE you attempted to solder them on? If not, likely, that is your problem.

After a couple of weeks my drone is alive again,just change the esc for a new one and today i gonna go to test it !!!!so fingers crossed!!

Sent from my iPhone using PhantomPilots mobile app

 

[Squirrel!]

Cool!

 

[Ohiowoodsman]

Not true. Scrape the coating off the wires and splice away.

View attachment 58113

I never did here what the problem was after u changed your motor

 

[Squirrel!]

I never did here what the problem was after u changed your motor

Who? Me? It was a bad bearing allowing lateral movement of the motor shaft.

 

[Ohiowoodsman]

Who? Me? It was a bad bearing allowing lateral movement of the motor shaft.

No, thought u had an issue after replacing it

 

[Squirrel!]

None. Only still have a slight 'whistle' from another motor that may or may not get replaced. The replacement is great, though!

 

[Ohiowoodsman]

None. Only still have a slight 'whistle' from another motor that may or may not get replaced. The replacement is great, though!

Must of been thinkin of someone else. U were definitely correct in replacing it though. When there's left to right that bushing's gone