Microraptor Pro Case Question

  • Thread starter Deleted member 27337
  • Start date
D

Deleted member 27337

Guest
Hey guys,

I just got my Microraptor Pro case and the lid hits my one prop due to its angle. Has anyone experienced this?

ImageUploadedByPhantomPilots1434747359.360257.jpg
 
mine is off on a weird angle, as well, but hasn't gotten caught yet. i still watch and make sure that it doesn't get caught in the lid when i close it.
 
that same prop is somewhat askew due to my MR case as well, but not as far as yours. My case closes well, though i would prefer that prop to be more straight. at first glance it seemed like it would not close but then as I lowered myself so the prop was at eye level, i could see there was plenty of room. do i see a little gap between the prop and the acrylic post in your image? I would definitely contact them to see what can be done (new foam or whatever...)

maybe use it without that one post until a more permanent solution can be found, i dont think removal of that post would result in any damage from being used in non extreme scenarios.

good luck!
 
Update: I took the phantom out and noticed that the foam under the Phantom was shifted/bumpy. I removed the main foam cavity and fixed everything. When I put it all back together it fits much better! Everything must have shifted around during shipping...
ImageUploadedByPhantomPilots1434749291.911454.jpg
 

Members online

No members online now.

Forum statistics

Threads
143,066
Messages
1,467,358
Members
104,935
Latest member
Pauos31