- Joined
- Feb 16, 2017
- Messages
- 24
- Reaction score
- 2
I'm new to drones and still learning all the terminology ect. My Phantom 3 standard,model W321, has no video streaming and the vision gimbal hangs limp, it seems a very common complaint. I've watch a hundred video's and searched all over, to no avail…… when it comes to real troubleshooting. I have a simple 8 pin ribbon cable going from the body of the craft to the gimbal/camera. Looking all over, I'm still not sure what the difference between a vision and a vision + is?
While all all these video procedures are helpful, for someone with some troubleshooting experience and equipment, I can't even find a pinout for the 8 pin ribbon cable. Does anyone know about this, without guessing? This appears like a strategic point to start for troubleshooting.
Further, can u have one or two motors work on the three axis gimbal without all of them mal-functioning? E.g. does a bad flex cable kill all the gimbal motors?
While all all these video procedures are helpful, for someone with some troubleshooting experience and equipment, I can't even find a pinout for the 8 pin ribbon cable. Does anyone know about this, without guessing? This appears like a strategic point to start for troubleshooting.
Further, can u have one or two motors work on the three axis gimbal without all of them mal-functioning? E.g. does a bad flex cable kill all the gimbal motors?