Inspire controller + p3p?

Joined
May 29, 2016
Messages
14
Reaction score
0
Age
49
If I use the inspire controller linked to my p3p. Can I get it to stay on the p3p permanently? If I link them and go back into the app it brings up only the inspire.
 
Joined
May 29, 2016
Messages
14
Reaction score
0
Age
49
Right now controller GL300B @ 3.152
A/C 1.10.90
I'm having issues, unable to update firmware through sd card. Tried 3 different ones. They were all reformatted to fat32. I previously had poor image transmission, pixelated/green screen. Now I have no video at all, and gimbal doesn't respond to wheel movements. I've manually linked it to the inspire controller, same issue no video, blank screen. It will tell me home point has been updated, upon start up the gimbal twirls around then stops, a few seconds later the gimbal makes a buzzing sound a moves very slightly with no input from the controller.
When trying to update it flashes red/green then about 3-5 minutes in the gimbal light turns solid red and buzzes.
 
Joined
May 29, 2016
Messages
14
Reaction score
0
Age
49
Well tried to update it again with the sd card. It did the red/green flashes on the gimbal, 3 minutes later solid red light and buzz/squeal noise. I read somewhere that it happens sometimes and to let it just do its thing. 30 seconds later I see smoke from the gimbal. Yanked the battery out and let it cool. Was doing this out in the yard where it was cool and breezy. Think I'm over it already.
 
Last edited:

New Threads

Forum statistics

Threads
134,963
Messages
1,396,283
Members
98,351
Latest member
hornblower