HOW TO: balancing Vison props (using Top Flite)

[Quattro1]

many people wondering on how to balance vision props, here is how I did it using Top Flit magnetic balancer.
This setup is completely without any modification at all, I have polished the magnets, but it's recomended anyway.

this balancer generates a very low friction, and the propeller gets a 100% senter lineup(nut has a recess in the front)

My "vision" propellers from china was completely out of balance

 

[Topeeka]

Thanks Quattro... When I ordered my Vision, I also ordered the Top Flite balancer, but it looked to me as if it would not work unless you could put the shaft through the propeller center... Good to see how you did this...I had not even opened the package, but it looks like I should give it a try....thanks for the tip and the procedure..

 

[Quattro1]

Thanks Quattro... When I ordered my Vision, I also ordered the Top Flite balancer, but it looked to me as if it would not work unless you could put the shaft through the propeller center... Good to see how you did this...I had not even opened the package, but it looks like I should give it a try....thanks for the tip and the procedure..

you are welcome..

but the props dosen't sit very firmly on the pin, due to the hard plastic on the senterholder, but it Works. You can easily drag a sticky tape againt the senterholder to improve it's holding capablilty.