Hello, I have a relatively simple question regarding the setup of the H3-2D with a Phantom 2. I upgraded the firmware via the Phantom 2 assistant software and am all up to date as of this writing. My question is this: under the "Advanced" section of the assistant software, there is a "Gimbal" section where it refers to the H3-2D. It asks if you want it turned on or off and then asks for an Output Frequency. Do I select "on" and put in a frequency?
Without doing any of this the gimbal powers up and seems to work. I just don't want to damage this sensitive thing in flight (which I haven't tried yet).
Thanks for any help!
Sam
Without doing any of this the gimbal powers up and seems to work. I just don't want to damage this sensitive thing in flight (which I haven't tried yet).
Thanks for any help!
Sam