Gimbal overload and pitch and roll errors on startup

[N321DR]

Hi,
I am new to PhantomPilots, however I have over 50 hours of flight experience with the P3S. The issue I am experiencing is when I turn the drone on, I end up either with the error message of gimbal overload or a gimbal pitch and roll tilt error. Sometimes I end up with the gimbal not even moving on startup. The thing is I don’t have anything blocking the gimbal (happens on flat surface too) and I am not sure why it is overloading. Also as a pilot in training, I know what pitch, roll and yaw is by this point, but have no clue what to do when it gives me an error like this. Please help! If I need to rephrase anything for clearance, I’d be glad to do so.

 

[quaddamage]

Looks like mechanic issue. You'd have to disassemble the gimbal and clean it, making sure all arms move with minimal force.
If that won't help - replace the flat film wire.

 

[N321DR]

Ok, I can try that. Thank you for your reply quaddamage