I'm guessing at some point you removed the .bin file from the SD card and then started up the Phantom again? If not, do so.
I've tried both methods, with and without .bin file in the sd card, but also redownloading the firmware and putting it in a freshly formatted sd card didn't start the upgrading process, my drone starts normally but without upgradingI'm guessing at some point you removed the .bin file from the SD card and then started up the Phantom again? If not, do so.
I've tried both methods, with and without .bin file in the sd card, but also redownloading the firmware and putting it in a freshly formatted sd card didn't start the upgrading process, my drone starts normally but without upgrading
I'm confused too!I'm a little confused. The app reports everything is updated and the drone starts normally. What is the issue?
I really don't know what happened, anyway here is my sdcard txt result:If you had red gimbal LED at the end of the upgrade, the process was not complete. You should if possible downgrade and then upgrade again.
Red gimbal led also means that sd card is missing