Hello
@Garrie;
I just tried to install the new firmware in my phantom 3 Pro and the remote control. I followed all the steps listed in the DJI site, but It didn't work in the RC, I have the GL300B RC, then I found in a forum that apparently can not be done by USB.
From the remote control now there are an intermittent beep sounds and blinking red light at the same time, also not connected with the tablet, the RC icon on the menu explains the following error: "Remote Controller FPGA error".
I tried to reboot, connect the drone, install again the firmware from usb and app, calibrate the RC, but I can not fix it.
I need your helped to fix it.
I hope to have your reply very soon because we go to shooting for a documentary next week.
I'm looking forward to your reply.
Cheers
