Fantastic First Flight

Morphious · Jun 24, 2015

After I tightened the gimbal screw and re-calibrated everything I flew it down to 50% and I am impressed, shot some pics and a couple 4K vids. I still get the gimbal overload error, firmware 1.2.6, P3P. I took off work today will fight the heck out of it, 10+ flights and some night flights tonight. She has a lot more power than my P2V3, locked on 12 sats immediately, hovered like a rock, turn off ground sensor but I never hover near the ground even with P2. Attitude is definitely your friend.

If I continue to see this error she might be going back, Amazon CameraSpot in PA

Morphious · Jun 24, 2015

Boxed up and shipping it back, via Amazon so easy, constant gimbal overload errors and massive jello in flight, this gimbal is bad.

Did 6 flights, both 4K modes and 1080 at 60Hz 30Hz, sad

AmosMoses · Jun 24, 2015

Did you make sure to remove the small white piece of foam from behind the gimbal? It was something that many were missing.

Morphious · Jun 24, 2015

AmosMoses said:
Did you make sure to remove the small white piece of foam from behind the gimbal? It was something that many were missing.

Yes, I ordered a new P3P today..

jasonb777 · Jun 24, 2015

My gimbal was damaged right out of the box from advexure ( which is not their fault) which I had to send back. The gimbal lock had fallen off in shipping which is very common on alot of orders. I had a slight buzzing when the cam was horizontal. But anyway I sent it back and they sent a new one within one week!