Went out for a flight and was faced with rapid blinking red lights, and the motors would not start. Once home I connected the Phantom and saw "Error 29". I tried the following -
Stumped, I decided to try a spare Tx controller. I updated the firmware and bound it to the Phantom. Same error, same result. Strange.
When I plug in the Phantom the throttle (T) read-out is super jittery and all over the place. You can see the status in the screen grabs showing that something is clearly wrong.
I have done a fair amount of searching and can't seem to find any useful information. I am hoping someone here might be able to diagnose the problem and offer up ideas.
- Re-calibrated the Tx using RC
Re-checked firmware, and everything is current
Switched batteries
Stumped, I decided to try a spare Tx controller. I updated the firmware and bound it to the Phantom. Same error, same result. Strange.
When I plug in the Phantom the throttle (T) read-out is super jittery and all over the place. You can see the status in the screen grabs showing that something is clearly wrong.
I have done a fair amount of searching and can't seem to find any useful information. I am hoping someone here might be able to diagnose the problem and offer up ideas.