So, it looks like the way the landing gear is connected to the rest of the drone is different in the Phantom 4 Pro V2.0 as compared to the Phantom 4 Pro, and it's really annoying because it looks like every video online shows the Phantom 4 Pro. Basically, as can be seen here, with the Phantom 4 Pro V2.0 there are only two antenna wires instead of four: a gray one and a white one; and more importantly the two compass wires are in opposite corners: the front left-hand corner and the back right-hand corner. Disregarding this AliExpress link, that's also what I see on my Phantom 4 Pro V2.0 that I took apart a few months ago.
So here's my issue: I'm trying to reassemble my drone, and one of the two compass wires that are in opposite corners is too short to reach to the Power Interface Module (the board in the front of the drone). I don't get it. I cannot flip over one of the feet, so that the two wires would come from the front of the drone, as the two feet aren't symmetrical. Somehow, everything was connected, but I can't figure it out.
Does anyone have experience with doing repairs with the V2.0 version of the drone?
So here's my issue: I'm trying to reassemble my drone, and one of the two compass wires that are in opposite corners is too short to reach to the Power Interface Module (the board in the front of the drone). I don't get it. I cannot flip over one of the feet, so that the two wires would come from the front of the drone, as the two feet aren't symmetrical. Somehow, everything was connected, but I can't figure it out.
Does anyone have experience with doing repairs with the V2.0 version of the drone?
Last edited: