- Joined
- Nov 15, 2014
- Messages
- 3
- Reaction score
- 0
Somehow all 4 pins going to the base of the camera came out of its socket. The 4 pin socket is still attached to the camera base but the wires with the pins are dangling next to the connector. The other end of this short gray ribbon cable goes up to the motherboard just below the USB port on the main body. I can re insert the pins into the socket and reconnect it to the camera base if I knew where each pin goes. (the socket is labeled 1 thru 4) Could someone please take a sharp close-up photo of their quad showing the 4 wire cable coming from the motherboard and into the base of the camera?? The connector I'm talking about is directly opposite of the MicroSD card slot. You will probably have to remove a couple of the shock mounts and roll the gimbal/camera assy out of the way a bit to get a clear view of the 4 pin cable run. Thank You, anyone that can help!