My IRC600mw Vid TX is mounted underneath on the belly of the phantom with the cloverleaf fatshark sticking straight out the back. I was bending it 90 degrees to get it to point straight down for better transmission coverage. I want to position the antenna lower, but I like the balance of the phantom and don't want to mount the TX on the leg.
I was thinking of getting a 90 degree antenna elbow adapter so the cloverleaf will point straight down from the TX's current position. Such as this one...
http://www.hobbyking.com/hobbyking/store/catalog/FR90DEGA.jpg
Here's my question...
By adding another connection between the TX and the cloverleaf, is it possible that I might be sacrificing a small bit of transmission power? as compared to just remounting the TX on the leg and not using a 90 degree connector?
Thank you
JB
I was thinking of getting a 90 degree antenna elbow adapter so the cloverleaf will point straight down from the TX's current position. Such as this one...
http://www.hobbyking.com/hobbyking/store/catalog/FR90DEGA.jpg
Here's my question...
By adding another connection between the TX and the cloverleaf, is it possible that I might be sacrificing a small bit of transmission power? as compared to just remounting the TX on the leg and not using a 90 degree connector?
Thank you
JB