2.4GHz Remote Control is not working

[djshughes]

I have a DJi Phantom 2, and upgraded the firmware (3.0), and now the Remote will not work? I can't start the copter, I can calibrate the remote, not sure why this is not working.

 

[Joel_t]

I have a DJi Phantom 2, and upgraded the firmware (3.0), and now the Remote will not work? I can't start the copter, I can calibrate the remote, not sure why this is not working.

Is the small green light on underneath the Phantom? I think that shows if the controller is synced to the Phantom? May need resyncing

 

[Rufus]

Hello.
I had the same problem and with some help from this board the problem was solved.
Look at this thread. Maybe it will help You too.
http://www.phantompilots.com/viewtopic.php?f=19&t=8854&p=73787&hilit=Can't+start+the+engines#p73787

 

[ginsonic]

I have a DJi Phantom 2, and upgraded the firmware (3.0), and now the Remote will not work? I can't start the copter, I can calibrate the remote, not sure why this is not working.

Just update the RC with RC assistant ,too.

 

[djshughes]

I Ran the RC assistant, and it calibrates in that program, however when I put the Dji Phantom 2 Assistant it doesn't seem to pair, I am confused as to why it works in calibration but not the other?

.

 

[djshughes]

and I tried the green button to make sure it was Green, it is. Does anyone have a picture of how the wires should be plugged into the Naza?

 

[djshughes]

Had the Remote control wires crossed, Great picture of the inside wiring:

http://www.rcgroups.com/forums/showthread.php?t=2054202

Then had a Error 29 after I cleared that issue, which when I ran calibration on the transmitter, and then a calibration, then advanced calibration cleared.

Thnak you all!!