cable

Hi guys I want to buy my first drone. I found someone who is selling his phantom 4, but i have my doubts. One of the cable is loose (see picture). What is/was the purpose of this cable. Is there a problem with the drone? Should i buy it or not? Thanks

I've seen a lot of pilots with their device connected to their controller with a cable. Is this helpful? Also I'm a new pilot and would like any tips if you have any.

Hi all. I crashed my phantom 4 into a tree. the landing gear broke and one wire that attaches to the compass has broke and requires replacing. I've obtained a replacement set of kegs but can not get the wire anywhere. anybody know where I can order one? it's the wire that clips on to the end...

Will the Phantom 4 RC accept either a Android or an Apple USB cable from the device being used to monitor?

Asked this over on P3 Std/4k Forum. Received no reply. So, I'll try here. Re the subject, on the top rear of the controller, there is a USB port with an individual cover. If one unscrews the 4 1.5mm hex head screws, the USB board can be seen. There is a single, fairly narrow ribbon cable...

Purchased used P4 yesterday. Got it home to hear something rattling in remote control. I was concerned it might be something metallic, possible shorting out something expensive so bit the bullet and took the back off the remote. I removed the (non-threatening - of course!) black nylon plastic...

Travelling lately and it seems i have lost part of the charger. Not the big brick (dont know how it's called) but the end that plugs into it. Is it possible to find that cable or do i have to buy the whole thing?

Hello All, While doing an antenna upgrade to my Phantom 3 controller, I damaged the ribbon cable that connects the main board to the USB board on the back. I could NOT find a replacement cable ANYWHERE! Apparently, DJI does not sell this part. After a long time searching, I found a local...

Hello All, While doing an antenna upgrade to my Phantom 3 controller, I damaged the ribbon cable that connects the main board to the USB board on the back. I could NOT find a replacement cable ANYWHERE! Apparently, DJI does not sell this part. After a long time searching, I found a local...

Hey guys, sorry if this has been asked already. I've done an extensive search and couldn't find an answer. Just wondering what length HDMI cable everyone is using and/or is most comfortable, when connecting from your goggles to your controller. I'm thinking 3ft should be plenty, but if I get...

There are two cables that run from the GPS in the drone cover to the body. I'm addressing the 5-wire gray cable that runs from the GPS board thru the body and down one leg to the compass. Here's the two "Quick Ones:" 1. What kind, make, whatever are the connectors on the ends called? 2...

does anyone know where to physically buy a flat gimbal cable near the Lake Tahoe area? Thanks.

The aircraft its self to an iMac itself using the USB cable that came with the phantom? If you can, Are you able to get the full resolution? Thanks Again

Hi, Today i noticed that my DJI was not going higher than 5M because of Signal lost error, my first thought that the antenna was the problem. So i screwed the controller open to find out what was wrong. I find that the cable is snapped from the antenna.. I contacted DJI and they told me that i...

Hi there, I just watched (at least) two dozen of video tuts on how to attach a Fatshark video transmitter to the Phantom 2 - and all of them are grabbing the power from that pre-installed 4-wire cable. However, according to the P2 manual, this cable does only provide 5V (with max 2A), whereas...

Selling the Gimbal/Camera from my phantom 3 advanced. As you can see from the pictures the Ribbon cable was damaged and now the camera shakes on startup. I went ahead and upgraded and ordered a new 4k professional camera so I didn't repair this one. Looks like an easy fix if someone had the...

The wires popped off of the port during a crash. I fit them all back in except for one which snapped off. Does anyone have any ideas for a fix without having to order another cable set? I've got a shoot coming up and don't think I have much time! Thanks!!!!

Crashed my P3P, the Gimbal 8-Pin Cable to MC was sheered off. I have the replacement cable, but I cannot thread it through the body of the Phantom like it was originally installed. Has anyone else solved this issue? or do you remove one of connection ends, wire the cable through the body...