Recent content by wayne hebb

#1 yes, everything is set up correctly. I double checked several times. #2 yes, everything is charged. #3 I am running DJI Go and have only done the required updates. #4 the area I am flying is over houses and businesses.. not a huge city, but there are power lines and other things that cause...

Ok, I have posted a few times lately to make sure I ordered the correct DBS antenna, the best 2.4 and 5.8GHZ amps, and the best performing battery to run the amps. Unfortunately, I am not getting the performance I was expecting... :( I purchased the ItElite DBS Antenna for my P3S. Then flew it...

I ordered this exact set up with the 2 2.4 GHz Sunhuns amps and 1 5.8 GHZ sunhuns amp. the amps are all 3 flashing like they are supposed to be. Everything appears to be hooked up correctly, but I am really not getting anymore distance than before the amps and battery. With the ItElite...

OK, do you have a battery suggestion?? And, if you don't use usb, what does it use?? Sent from my SM-T350 using PhantomPilots mobile app

I was only going to run one 2.4Ghz amp and one 5.8Ghz amp so, I got the battery for that application. However After speaking with several other people I decided to go with 2 2.4 Ghz amps... is there a battery with 3 USB ports instead of 2?. Or, is there a battery and a different methods otf...

If your remote set up is neat, I would love to see a picture... my antenna wires come out of the bottom of my remote...

I have the ItElite antenna installed on the remote for my P3S and just received the 2.4 and 5.8 Sunhans amps, the battery, and all wires and mount to boost the signal... I am finding it impossible to find a diagram that shows exactly how to hook it all up.. What amp goes where? How do the...

what is "Jake"'s website??? I want a Itelite DBS for my P3S and I fly in an area with a lot of houses and interference... I would love to get a boosted setup

I am flying around houses and some power lines, but no major cell towers or anything bigger than typical residential power lines... I have the wind surfer now, but that has not had much effect... One flight I made it out to 1500 feet with the wind surfer which is a bit further than stock, but...

How is that even possible? I have a stock p3s and i don't get close to that distance... at about 1000 to 1500 feet i lose signal... i can still see the drone, but I still lose signal... is it the area or number of satellites or is it not really a stock p3s or what? Sent from my SM-G935P using...

How do you go back to version 3.0.1 with Google maps?

Does the Litchi app have the same issue? I have the Litchi app and really need the map... I flew the wrong way several times because I got used to using the map for direction...

For the last two flights, my small location map is not working. It is not showing where I am. It does not have any of the street names. And there's no line that points back home. It is basically just a gray screen with the drone arrow in the middle.... I tried to open it, but I just got...

Thanks to everyone. This forum is great!! I did a very basic preflight check,but nothing like the checklist above. I guess it pays to be careful and I am sure after doing it a few times, it will go fast... I initiated the RTH command today using the app and when the battery got too low. I...

It is very possible that I was just impatient and didn't wait for it to happen. I just got nervous when I lost connection because I did not want to crash. I wasn't far from my home point so I was able to just walk until i reestablished a connection. Then I was able to resume control. I...