Ok, I did receive a login to Go4 app screen. After I see the Go4 app icon on my Air 6 I click it and it goes to GO Fly. Aircraft warms up
and after I'm air bourn I discover I can't go beyond 100'. Uninstalling Go4 and reinstalling in an attempt to correct problem is not problematic
but does seem...
I power up remote and P4 and login Go4 app. Gather satellites and take off but stops well before 100'.
Not in beginner mode. RTH set at 120 m and altitude 500m. New IMU calibration method of placing aircraft
in 6 positions including upside down seems excessive .
After new firmware update my P4 ascends to about 100 ft. or less and audio message
maximum altitude reached. It is set to the max. but I can't even get over the treetops in
my driveway . Everything was fine until the Russians colluded to disrupt sound, innovative and
reliable firmware in the...
I'll try and see if message comes up again. I don't think battery is bad just needs updating. My Air 2 downloaded the DJI Go 4 app. but don't know why battery didn't update when P4 updated?
Thanks for your help in trying to resolve issue .
Phantomsphere
Now startup message reads battery error. In the go app message
Now reads "invalid battery" as though it was not a DJI battery? I remember seeing " inconsistent firmware detected"
message once, then battery error ,now Invalid battery.
Connections are clean, no damage to charger or battery. Other battery works fine?
Can this problem be resolved or has battery failed? Go App shows Battery Error at start up?
No, I did not. Can you list procedure? Judging from your expertise that would indicate the logs would show the reason for failure during flight, yes. I alternate between 2 batteries and it is
the first batt problem I have encountered with the P4. My P3P has 3 batteries never a problem. I...
No battery was near outside temp of 68 degrees F . When I took off batt was fully charged. 2 min into flight batt had dropped to less than 50% . Landed P4 Go app
flashed Battery Error. Charged batt again but same error appeared. Battery is only 7 month old but seems to have permanent error...
My problem is the (disconnected msg.) is at start up. I turn on RC then the P3P and
then the Nvidia Shield. I can start props and take off but rather have
connected P3P with camera working. Cables won't arrive till 11/30/15
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.