Recent content by boomer632

That stuff is definitely not your typical silicon bought at the hardware store. My concern is any possible type of reaction that may occur between an electronic component and an adhesive like store bought silicone or such. Hot glue probably wouldn't have a reaction but it would be quite...

Does anyone know of a glue that is equivalent to the white glue DJI uses to secure the compass and other parts in the controller? Sent from my SM-G930P using PhantomPilots mobile app

I just replaced my P3P gear due to a cracked leg. The new gear did come a compass. I chose to use the original because I didn't want to open the shell. The real pain of the job is freeing the compass from the glue that DJI used to secure the compass. Don't know what that stuff is but it sticks...

Thanks for clearing that up

If my RTH is set to 300 feet and I'm flying at say 400 feet when I lose signal, will the AC descend to 300 feet when RTH is triggered by loss of signal or weak battery?

Looking for an undamaged ribbon cable for P3P RC USB Module. PM me if you have one for sale. Sent from my SM-G930P using PhantomPilots mobile app

If you messed with the black ribbon connector in the USB module then probably so. Sent from my SM-G930P using PhantomPilots mobile app

What mod? I had same issue after dbs mod. Prob controller usb module ribbon Sent from my SM-G930P using PhantomPilots mobile app

Yeah I know. I wanted to get an hdmi module anyways and that has a new ribbon clip which I believe is the problem. Sent from my SM-G930P using PhantomPilots mobile app

It's the rc ribbon that connects the USB module to the board. I may have boogered up the connector upon further inspection. Good thing I have an hdmi module on the way. Sent from my SM-G930P using PhantomPilots mobile app

Yeah the USB makes sense. I got the ribbon in up to the white line. I hope I didn't damage the ribbon cable. If by chance I did damage that ribbon, is it available anywhere for purchase? Sent from my SM-G930P using PhantomPilots mobile app

I just installed the DBS mods in my p3p. Some difficulty with the ribbon connection but I got it. When I got everything connected and powered up the bird would not connect to go or litchi. The light on remote is green and I'm able to tilt the gimble up and down. I tried to re link the rc but...

I don't get why the 10 firmware bricks some birds and not others. I upgraded mine a few weeks ago and have had no issues. I did however downgrade my rc down from latest version to 1.8. I'm running a iPad air wifi. I had most of my transmission issues when I was running dji go on my android...

Ok well that clears that up.. wont be getting a GPS. Guess Ill have to rely on my crappy Sprint cell service to hotspot from my phone. Might as well have 2 cans connected by a string..

OK I guess my main question is this hypothetical scenario.. I take my drone out to an area that has no wifi or available data whatsoever and I have not previously cached the map in the area prior to my arrival. If I use a bluetooth GPS device at this new location, will the new area map show up...