- Joined
- Jul 3, 2018
- Messages
- 8
- Reaction score
- 8
- Age
- 75
I have had my P4P V2 for about 4 days now. I took it to a friend's large ranch to give me lots of room to practice. I especially wanted to begin practicing a few of the intelligent modes - specifically Draw, Tap Fly, Tripod.
When using DRAW P4P was perfect. Fly to the object/area and maintain perfect altitude start to finish.
When I used TAP FLY, and tapped on a distant object , it looks as if TAP FLY descends directly to the object/point at the angle established from the drone to the point when "tapped."
As my first TAP FLY flight progressed the ground got closer and closer and closer . . . until I intervened and hit stop.
Question - would it have flown into the ground?
Thank you for any answers, insights and advice.
Ed
San Antonio, TX
Disclaimer:
Yes, I have
- Downloaded and read the entire owners manual
- Searched this forum
- Watched numerous YouTube videos, including:
When using DRAW P4P was perfect. Fly to the object/area and maintain perfect altitude start to finish.
When I used TAP FLY, and tapped on a distant object , it looks as if TAP FLY descends directly to the object/point at the angle established from the drone to the point when "tapped."
As my first TAP FLY flight progressed the ground got closer and closer and closer . . . until I intervened and hit stop.
Question - would it have flown into the ground?
Thank you for any answers, insights and advice.
Ed
San Antonio, TX
Disclaimer:
Yes, I have
- Downloaded and read the entire owners manual
- Searched this forum
- Watched numerous YouTube videos, including:
