Hi everyone - first post for me on this forum.
Had a P2 for a few months with FPV and got my T14SG last week - I'd like to thank Ian for the profile and also all of the community responses to this post across the first 43 pages which have saved me a lot of time in setting things up. AWESOME sharing guys, thanks.
Couple of things / comments:
1. I've seen a few comments on how to get two different speeds for the gimbal tilt. While I know there is no solution with the motor function (some for of speed dual rate), I've left it as per Ian's v4 profile and also reduced the SERVO SPEED against GEAR. I don't really need the default full speed for anything as it's too quick anyway, so reduced the speed (not as slow as the switch) on the actual channel, and using the MOTOR and mix switch for the 1-45-90 "super slow" tilt.
2. on the same topic, the ideal scenario for me would be that the 3 way switch would be used as "true" incremental on the RS, but without the angle presets - not sure if that's doable. Example:my RS is set at 30 degree as a starting point.
* if the switch is in the middle, nothing happens
* if the swicth is flicked up, this triggers the slow tilt to go up, until the switch goes back to the middle or hits the endpoint
* vice versa, if the switch is down, slow tilt goes down until you put it back to middle or hits the endpoint
while this would have challenges if you are operating in blind, but with FPV I see greater control with this solution - just don't know how to make it happen
3. does anyone have a solution on adding a channel for shutter control on the hero3, or even switch from pict to video? you would think the gimbal should be able to deal with this as it has interface back to the P2 motherboard? If not, any third party solution that doesn't involve taking your gopro apart and soldering stuff to the buttons?
Thanks
Nico