P3 Remote - Which antenna is Video Which is RC?

[marphtwo]

Hey guys,

Take a look the 2 green arrows at the bottom in this picture. Can anyone tell me which antenna port is for the 2.4GHz RC TX and which is for the Video RX (5.8GHZ?)

 

[dirtybum]

If thats p3a or p3p then both are 2.4

 

[marphtwo]

If thats p3a or p3p then both are 2.4

Did you use a spectrum analyzer to verify?

I doubt that both video and control are on the same frequency.

Can anyone else verify?

 

[Solar Deity]

I thought they (P3P/A) were MIMO, in fact sending control and video via the same 2.4 GHz frequency.

Someone will confirm.

SD

 

[Shammyh]

Did you use a spectrum analyzer to verify?

I doubt that both video and control are on the same frequency.

Can anyone else verify?

This has been studied by myself and others.

Video is transmitted in a 10 mhz wide signal, and the control signals is some sort of frequency hopping spread spectrum.

Both are within the 2.4 GHz ISM space.

I discussed my findings with an rf analyzer here: Phantom 3 Channel <-> Frequency Table | DJI Phantom Forum

I do believe though, that one antenna is transmit, and the other is diversity receive, but I haven't had a chance to prove this theory yet.

 

[gppms]

Lo

Hey guys,

Take a look the 2 green arrows at the bottom in this picture. Can anyone tell me which antenna port is for the 2.4GHz RC TX and which is for the Video RX (5.8GHZ?)

Take a look at this video:

To view this content we will need your consent to set third party cookies.
For more detailed information, see our cookies page.

Accept third party cookies