I have a p3s,and I have no gimbal movement ,new yaw ,roll and pitch motors,new ribbon cable new main board for gimbal all alignments are correct. Can anyone help?
Need help
- Thread starter Thunderhorse
- Start date
Possibly some aftermarket parts that may not be up to the task? DJI products are a little particular at times.
I've read it posted here......"That IF you have to install a new ribbon cable....you plugged it in to install it...The Copper foil is so thin it IF you have to unplug it ONE more time and plug it back in.....Its so thin That one more time is all it can stand...it will cut its self thru.....and THE aftermarket ribbon gimbal cable is Of lower quality i have read that here a few times too and that just MIGHT be your issue ...Good Luck on the trouble shootn !
Unplug the ribbon cable from the gimbal. You should have 12 V on four of the wires on one side of the ribbon cable. The other four are ground. See if you have power going to the gamble.
If you got them direct from DJI, which I’m not sure that is possible, I would go along with that. I have seen tons of parts for sale on various sites that either claim or make the packaging look similar to DJI, that are in fact not from DJI. Hope you got what you thought, but it may be worth another look to verify.
Well I am in the process of switching over to the Yuneec Typhoon H,from what I have seen and delt with it is the superior drone. Dji is not a very helpful business to contact ,they seem to be more interested in collecting the 100.00 fee for just looking at your drone and that is the first thing they tell you is to send it in!!!
Yep, that's their first response. Been there, done that. Lol
I still think DJI has a superior product.
I still think DJI has a superior product.
