I have a Phantom 2 with a Zenmuse H3-3D and just installed a few upgrades. Namely:
1) 5.8GHz ImmersionRC 600mW TX
2) iOSD Mini (also updated the firmware to v1.06)
3) DJI Phantom 1 or 2 Extended Wide Landing Gear
4) Black Pearl 7CH RX
5) 5.8 GHz Cloverleaf Circular Polarized Antenna Set (RHCP) FlySight CPA5G
I watched this video to do the install:
http://youtu.be/TL8pqtEDuos
As well as this video for the H3-3D install:
http://youtu.be/yOoU-RftvV8
I tested everything out and it works fine, except once I start the Phantom...there are NO green lights at all or yellow to try and get satellites. Has anyone had this issue before? The Black Pearl shows the satellite icon blinking on and off repeatedly, but I only see ATT in the lower left hand corner. I'm wondering if it has something to do with the new placement of the GPS chip on the new landing gear. The post is too wide to fully get around it, but it is attached.
Any help is appreciated! Thanks!
1) 5.8GHz ImmersionRC 600mW TX
2) iOSD Mini (also updated the firmware to v1.06)
3) DJI Phantom 1 or 2 Extended Wide Landing Gear
4) Black Pearl 7CH RX
5) 5.8 GHz Cloverleaf Circular Polarized Antenna Set (RHCP) FlySight CPA5G
I watched this video to do the install:
http://youtu.be/TL8pqtEDuos
As well as this video for the H3-3D install:
http://youtu.be/yOoU-RftvV8
I tested everything out and it works fine, except once I start the Phantom...there are NO green lights at all or yellow to try and get satellites. Has anyone had this issue before? The Black Pearl shows the satellite icon blinking on and off repeatedly, but I only see ATT in the lower left hand corner. I'm wondering if it has something to do with the new placement of the GPS chip on the new landing gear. The post is too wide to fully get around it, but it is attached.
Any help is appreciated! Thanks!