Hi
Just got a new P2 with a Boscam Thunderbolt 1000mw transmitter and ISOD Mini fitted by the supplier. I am using it with a supplied Boscam monitor and Cloverleaf antennas.
After installing my Zenmuse H3 3D and GoPro Hero 3 Black I have tested out the FPV as its too wet to fly! Each time I use it I get a reasonable image with a little interference for about 30 secs and them it cuts out to static. I am thinking it might be overheating as it works for this short time but them won't give you any image again unless you switch off the Phantom and leave it for a while. It them works again for about 20/30 secs and cuts out. Any suggestions to try or is it simply a dud? This is my first time using any FPV system.
cheers
bill
Just got a new P2 with a Boscam Thunderbolt 1000mw transmitter and ISOD Mini fitted by the supplier. I am using it with a supplied Boscam monitor and Cloverleaf antennas.
After installing my Zenmuse H3 3D and GoPro Hero 3 Black I have tested out the FPV as its too wet to fly! Each time I use it I get a reasonable image with a little interference for about 30 secs and them it cuts out to static. I am thinking it might be overheating as it works for this short time but them won't give you any image again unless you switch off the Phantom and leave it for a while. It them works again for about 20/30 secs and cuts out. Any suggestions to try or is it simply a dud? This is my first time using any FPV system.
cheers
bill