I know the re-link button is to re-establish WiFi link RC to AC ...
OK - just re-installed 1.07.0090 - not possible to install any other FW ... honest - I've tried.
I had all 3 on when I inserted SD Card ... nothing happened ... I had to restart AC with card in to get installation to start.
After 3 - 4 minutes :
The RC shows Green and locked in.
Go App has Standard up but New Formware available banner .... and Initializing - please wait at bottom.
AC has green light above camera but the Re-Link button is blinking twice red then once green repeatedly.
I have not switched of and restarted - just leaving all to see if its just a long process !! I have a fan running on the camera and gimbal to avoid overheating. I will give it about 30 - 40 mins and then restart all.
Anyone have any clue what the blinking and Initializing is ??
(I have just touched gimbal control on RC and it works ... so link is there).
Nigel
OK - just re-installed 1.07.0090 - not possible to install any other FW ... honest - I've tried.
I had all 3 on when I inserted SD Card ... nothing happened ... I had to restart AC with card in to get installation to start.
After 3 - 4 minutes :
The RC shows Green and locked in.
Go App has Standard up but New Formware available banner .... and Initializing - please wait at bottom.
AC has green light above camera but the Re-Link button is blinking twice red then once green repeatedly.
I have not switched of and restarted - just leaving all to see if its just a long process !! I have a fan running on the camera and gimbal to avoid overheating. I will give it about 30 - 40 mins and then restart all.
Anyone have any clue what the blinking and Initializing is ??
(I have just touched gimbal control on RC and it works ... so link is there).
Nigel