Sure did! Now I can lose those little puppies with abandon! The set ran about $12 and change from Amazon (TEKZ) with the smallest size being the 3mm .5 set screw that I lost when repairing my Zenmuse gimbal. Which brings up a thought I had earlier with regard to repairing it and others when another crash occurs (not IF!). Two items would be most handy, one being a gage that would fit into the shaft holes of the arm (vertical and pitch arms) so that you'd know that you were back to factory dimensions.
The second would be a small plastic fixture or even a circuit board that can be placed into the Zenmuse mounting plate with two small contacts (rivets, screws, or other conductive material) that are wired together, the positions of the contacts being placed such that they would short out the Zenmuse RESET contacts on the mounting plate. It would be quicker and easier than trying to use a pair of scissors or other means of trying to hit those small contacts which I have done in the past. Both projects seem achievable in a day's time, especially on a day like today here in paradise where the wind is blowing at Mach 2 and rain enough to make Moses think twice about taking a stroll!
View attachment 41169