Good insight. Haven’t updated firmware in at least a year, running latest GO on iPhone 7+, which should be new enough.
Haven’t used litchi recently since I couldn’t even get into the drone. Now that I can, I’ll try it again.
I’ve had my p3s for 2 years with very little issues. A few months ago I took it out to fly and it said the password was wrong (I had a previous thread regarding that). I then had a few weeks of testing and recalibrating.
Took it out today: connected to Wifi right away (previously that was a...
Got my phantom reconnected. The worst part: didn’t do anything different than before. It connected to WiFi, then controller, then the ‘bind’ button on the drone.
Didn’t fly because it’s raining, but looks like it would be fine. I’ll give it a shot tomorrow.
Yesterday I had another p3s out to do some testing. I could connect my phone to the other p3s and fly fine, so the app isn’t the problem.
My phone DID connect to my controller outside (this was new, wouldn’t connect at home), but still wouldn’t connect to the drone.
When I loaded the...
I believe the drone and controller are linked. When I start airplane mode, then select the drones WiFi (which is how I have always done it), now it just infinitely loads. Never gives me an option to enter a PW or anything. Going to DJI go, it just says “disconnected”.
I’ve done the ‘hold gimbal dial to the right, toggle S2 switch rapidly’ protocol to activate the red/green blinking lights, imagining it reset the PW to 12341234.
When I try to connect to the phantom WiFi now, it just won’t connect, doesn’t even give an option for a PW like earlier.
Finally a beautiful day to fly, go to connect to my Phantom WiFi (like I’ve done hundreds of times)... and it says the password is wrong.
I re-enter it. Then again. Ok, maybe I changed it (but, I didn’t). I try a few other PWs it might be. No dice.
I open up DJI Go to change the PW. Can’t...