Recent content by rogerhall59

I find the regular CS 7.85 is perfectly adequate and without issues. It is also lighter. The ultra is overkill.

My CS Ultra failed today after 30 minutes into a flight with my Mavic Pro. It just went dark. I have used this unit for less than 3 hours. It got very hot and I did not hear any fans. My regular CS is working fine, thank goodness. Looks like a trip to DJI is in the future.

I have ordered the ultra. Hope things go smoothly . My 7.85 replacement and original both booted up easily. I will let the board know.

DJI replaced my Crystalsky and the new one has worked flawlessly. This tablet is the best thing that has happened to my drone flying. I have the DJI googles and hardly use them anymore.

I sent the Crystalsky back to DJI and they replaced it after three weeks. The new display is working fine so far.

The plane disconnects and the screen freezes on the last transmission. The only way to reconnect is to shut down the tablet and start all over again.

I spent quite a bit of time with DJI support and we went through all the steps outlined by mad angler 1 and buduck. Nothing worked so DJI authorized a repair return. I sent it back last Friday and will let you know of developments. When it is working the Crystalsky is by far the best solution...

The Crystalsky screen locks up regardless of the range. I do my filming close in and that is where most of the lock ups occur. I have to completely power down the tablet and reboot the ap to reconnect. Fortunately, it does not impact the controller.

I received my Crystalsky last week and had several wonderful flights. Two days ago the screen started locking up and it has done so every flight since. This is happening on both my Phantom 4 and my Mavic Pro. I called technical support twice and they were not able to give me a solution...

My Shield worked until it upgraded to 7.0. How can I get 6.0 back?

i have a Nvidia Shield K1 that I use with several drones with excellent results. The Shield does not process the video on the P4. I sent the P4 back to DJI for this and other issues. DJI replaced the camera but it still doesn't work with the Shield. I called tech support yesterday and John...

I had a similar problem with my P4. I flew it 50 times using DJI GO without incident until I fell for the prompt that told me to update to DJI GO4. I upgraded the app and took a ten minute flight to confirm that everything was functioning. I landed, got out my manual and took off, hovering...

I hope my incident was an anomaly which it appears from the responses. The drone was just hovering at 8' when it started gyrating, worse each time, no response to controller, including the kill engine stick response. Finally flipped and drove itself into the driveway. I put the whole package...

I have a mini i-pad 4 that I use for my other drones. When I tried to upload the DJI to the 4, the app said it was not compatible. The 4 was running 10.2. I called tech support and they said the program was not compatible with 10.2 but it was with the earlier versions. I bought a new mini 2...

I was using a mini ipad 2 which had just received an update to 10.2.1. That may have been part of the issue.