Recent content by MythicalFlyer

Super Glue (Cyanoacrylate).

Temporarily repaired the cracks with glue and so far so good. Have done about 10 flights since and it seems to work.

How do prop guards reduce cracking?

How concerned should I be about the drone breaking up in flight? Does it happen?

Did you replace the shell or used glue?

Hi. I noticed these cracks on the upper shell just below the left rear motor. Structural or cosmetic only?

Never used any detergent.

Thanks. Unfortunately both of those settings were already set like that. USB configuration is set as MTP and USB debugging is off.

One of my batteries also developed a crack. I contacted my supplier and they said it's cosmetic only and not something serious.

Hi, I have a Phantom 4 and Samsung Galaxy Tab S3. About half the time my tablet restarts when I turn on the controller. It doesn't matter if I first turn on the controller, then connect the tablet or first connect the tablet, then start DJI Go, then turn on the controller or turn both on, then...

I bought mine because it was on a 24% discount. I don't use it only for the Phantom (actually it is now my main computer). I bought a Tab A 8.0 2016 for a huge discount when I bought the drone last year and while the Tab A ran DJI Go just fine at first, the 8 Gb internal memory of the Tab A is...

Thanks for the answers, I went ahead and bought a Tab S3. Fits very nicely, and I use the lanyard (but I use it always anyhow). The experience on the big Amoled screen is very enjoyable! Have good flights everyone!

Thanks. I take it you have to stretch your cradle to its max then?

Will a Samsung Tab S3 9.7 fit on a Phantom 4 standard controller? According to specs the Tab S3 is 169mm, and when measuring the controller it seems a very tight fit. Anyone using this combination?

Happened today when I tested at in the middle of the day. Also, it is not the forward looking VPS (I had the 'into the sun' VPS-auto-stop a couple of times). It is the downward sensors.