Recent content by morgan5518

Antenna appear undamaged and in place as far as I can tell.

Ok I will check the main esc board after work tomorrow and see if that could be the problem. The main gimbal stayed on the drone in the crash and only the part from where the photo shows the camera disconnected was ripped off in the crash.

Ok I have checked All cables going into my and gimbal and all seem to be connected properly. Still having the same connection problems

Hi yes I think this is all the photos you need shoot me another message if you need any more photos. The gimbal ribbon cable tore in half and I removed it from the drone. I can arm motors and fly the drone in both altitude and gps mode with just the controller as a bit of additional information...

Hi guys so I crashed my drone and ripped the ribbon cable but before I buy a new one I have found a possibly bigger problem that maybe you can help with when I plug my gimbal in obviously without the ribbon cable my telemetry for the app keeps disconnecting and wont stay connected for longer...

So I crashed my drone. Which tore the gimbal ribbon cable and now when I turn the drone on and connect the app I lose the signal every 5 too 10 seconds before it recovers is the gimbal ribbon cable needed for stable connection or have I damaged one of the radio transmitters Cheers for any help given

I have done it know I used fingers and that method

Thank you very much will order a new ribbon cable this afternoon and will post on here the results

Thank you very much my up and down bit of the gimbal isnt working so I thought o could be missing some cables

How many wires should there be connecting the gimbal to the drone. Not the individual wires but the one with the big connector. I have 8 not sure if it should be 10 or 8

My yaw motor is completely limp with power on. I can't get the drop pins off and I have no spares. Can j use cable ties or do they not work as well

Also it is used

It is limp when on gimbal light is green Will try calibration tomorrow in morning and post result

So i tested out my new phantom 3s yesterday and the up and down bit of the gimbal didn't work not even a hint of movement is it the motor or a cable problem do you think

Can you send me the link please as it's returning no results