Recent content by Mdeblasi1991

Never mind, sorry. I found it on DankDroneDownloader in the Phantom 4 Pro sub-menu. They have V01.04.01.00. In order for the file to be recognized by your controller, you have to rename it to "GL300E_V_1410.bin" before inserting the SD card and attempting to perform a local update.

Does anyone have a copy of a firmware prior to 1.4.3? Thank you.

I have big boxes full of propellers that I'd like to clean, but it's very time consuming. Does anyone know of a product that I can soak them clean with? Thanks.

I can confirm that it did not work for a P4 Pro or Pro V2.0.

Does anyone know what drones the GL300N is compatible with besides the Phantom 4 Pro RTK? Thanks.

Perhaps I damaged something by using a magnetic screwdriver? I've ordered a demagnetizer and will see what I can do tomorrow...

I've just refreshed the firmware and there was no change. I will attempt to reconnect the cables.

Hello, I've replaced the landing gear for compass 1 of my Phantom 4 Pro, however, it still displays as "disconnected." Is there something that must be done after the replacement for it to be recognized as connected, or should I assume that the compass cable is damaged? Thank you!

Do you know of a way to revive a limp speed controller with yaw and roll errors? The camera moves up and down on startup, but then goes limp.

Yeah, it’s too far out. Thank you though.

I replaced an ESC that seemed dead (the camera was limp and there were yaw and roll errors in DJIGO4), but the camera is facing to the right after the replacement. Is there any sort of calibration software I can use? I’ve tried the obvious: IMU calibration, compass calibration, firmware refresh...

The USB board within the back of the controller and the main board within the controller. The DJIGO app displays the firmware version on the USB board I believe, but I’m not certain. I’m fairly certain that he mismatch between the two causes update failures though. Like if you use a replacement...

I suspect the firmware versions associated with the USB board in my controller and the main board do not match. Is there any third-party software available to flash firmware for the GL300B? Or does anyone have a solution to this issue? Thanks.

I believe the V2 doesn’t have the small board in the top of the gimbal, but what about in the camera itself? Are these any differences?