Thanks Crash! That's exactly the info that I needed. I already figured out where the 4-color wire goes, so no worries. Just had no clue where the two black ones went. And an additional thanks for mentioning which direction they plug in, I was concerned about that. Thanks!!!
Had a crash and most of the wires disconnected. Need help in knowing which connectors to re-attach wires to.
- There are two sets of 3-conductor black wires for the motors. One end is still attached to motor(s), just need to know which connectors on control board to attach them to.
Then...
Ok thanks. Yeah, Ranger003 put me on to that thread last week. I can't gather how to do what I want from that, but I will PM him directly and ask.
Thanks.
Got it figured out and it works now. As I said before, Kerri at RotorPixel had me order a new control board.
Now I have two questions because I can never seem to get in touch with him:
1. How can I copy the firmware/settings from the new board to my computer for backup?
2. How can I transfer...
Got it figured out and it works now. As I said before, Kerri at RotorPixel had me order a new control board.
Now I have two questions because I can never seem to get in touch with him:
1. How can I copy the firmware/settings from the new board to my computer for backup?
2. How can I transfer...
Have solid red and flashing green.
Yes, replaced IMU as well, with a new cable. Have tried both ports forthat one. Have triple checked all cables a thousand times. Checked videos on web and all cables are connected to correct ports.
This is very frustrating.
Red solid light inside board, and a green flashing light.
When you say "updated" transmitter, do you mean some kind of new transmitter other than the one that came with the P2V, or are you talking about a firmware update?
Either way, when powering up the P2V the gimbal acts dead regardless of...
HELP!!! (please)
I got a new RotorPixel gimbal back in January, installed gimbal, rocked it by hand, gimbal worked great. Took it out for first actual flight, had it in the air for less than 10 seconds and it crashed into a small bush upon take off due to a very strong wind. It was only at 5...
HELP!!! (please)
I got a new RotorPixel gimbal back in January, installed gimbal, rocked it by hand, gimbal worked great. Took it out for first actual flight, had it in the air for less than 10 seconds and it crashed into a small bush upon take off due to a very strong wind. It was only at 5...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.