Recent content by K Supertramp

I said I tried that originally ( fly higher than the vps (“I cannot take my eyes off it unless I fly it 50’ or above the obstacles “ and I also said tried in different modes all had the same result! ) another poster asked if I tried switching modes to see if it becomes stable and I said yes! You...

I’m get a aftermarket UV (screw on filter) I think removable ones would work better for me because I’m using a camera clamp that slides onto the lens. The OEM one was just to clumsy to handle, I hope to find slide on filters like the polar pro filters I have for my mavic but it seems all the...

i give up other drones fly fine in the same places including other Dji drones. It was a mess when I got it as I said, I don’t know what it’s supposed to lock onto if grass and everything else will confuse it? It’s advertised that it’s supposed to be stable for indoor flight (No I haven’t tried...

.

Anyone try filters from this place they seem innovative!Products Products

I just ordered the goggles and am not able to see well at a distance without correction:( it’s been a challenge because my vision was 20/10 most of my life until about 18 months ago! My prescription is not that strong so I’m hoping these goggles will work for me it’s ashame Dji didn’t think of...

.

I They never seem to mark the antenna leads this guy pulled the downward sensor off intact by pulling the wires through the shell still attached to the board, Someone posted the correct wire position thanks

I was wondering if it was orientation specific like the gps uses satellite position I guess if the wires were on the wrong posts on the board then it would not cause a stability issue? The drone seems to drift when hovering sometimes 10’ in any one direction! Even with it in GPS mode (12 plus...

Does the orientation of the antennas make a difference in the flight? Would a mixup of the OFDM connectors have any ill effect to the drones flight?

Is there a way to increase the cooling? A better fan etc?

Thanks I searched for days and couldn’t find it anywhere.

I just replaced the Camera and Gimble on my Project P3P that I’m rebuilding the old camera had a White fan on the Gimble the new one has a Black fan with a chrome guard, is there a difference is one better then the other?

Get some electronic cleaner spray radio shack had it but they shut down a lot of if not all the stores (I’m not sure if they went out of business across the board?) it comes in a can like wd40! I had a expensive electronic item take a bat and used WD40 to clean it and force the water off/out of...

I am rebuilding a P3P that was put together incorrectly by the seller it needs a shelll I just replaced the camera, but it’s drifting strangely? It stays in a area about 10’x10’ I am pretty sure it’s supposed to be more stable than that? I don’t think the previous owner put it together correctly...