Hi all,
I recently got the P3 pro and was pretty happy with everything (minus a few glitches), however all of a sudden my video quality is grainy and looks like digital noise, anyone else experience this and/or know how to fix it? I have a job to do in 3 days and if i don't figure it out I'm...
i am using the stock props, i suspect i didn't tighten it right.
I went to a local hobby shop nearby and we came to the conclusion it is the ESC board, we noticed a bit of condensation on it. Going to replace it. Does anybody know what these cost and the best way to order them. I'll go through...
ps I think i might know the culprit for my bummed motor. I bought a carrying case off Helipal and it may not have been the right size. The lid of the case came down pretty close to the top of the rotors, however it was hard to tell. Its the only thing i can see that may of bummed out my rotor...
Thanks for the replies.
-LEDs are working fine
-no difference in heat on motors
The one rotor skips a few times and then gets going, i suspect it may be lagging slightly. This morning I took it out to fly and on take off one of my props flew off and the whole thing came down on its back from...
I ended up going to a local hobby store and got someone to solder the video Transmitter wires for me. Gopro and gimbal work great. After one test flight though, we realized that one of the rotors was "stuttering", we took the lid off and started it up again and it was fine. I thought maybe i...
I ended up going to a local hobby store and got someone to solder the wires for me. Gopro and gimbal work great. After one test flight though, we realized that one of the rotors was "stuttering", we took the lid off and started it up again and it was fine. I thought maybe i tightened the lid too...
thanks so much for getting back to me and i do apologize as I am so new to this and not the most tech guy....
when you say P2 board, you mean inside the phantom correct? I accidentally stripped a screw and can't open it now. I'll have to figure out that one later. Im going to see if I can trade...
right now i don't have my transmitter connected to the HUB as the connector doesn't fit into any of the slots. Seems like the HUB only likes certain transmitters. Looks like I'm back to the problem as to why i bought the HUB in the first place...soldering. ahhh.
Hello!
Im trying to set up my FPV (Storm all-in-one) on my P2 from Helipal. I hooked up the video cable to the go pro, however i don't know where to connect the power supply from the transmitter, do I need to open up the lid? Also I stripped a screw when i was trying to take the lid off, now i...
Re: Soldering wires for the IOSD mini and Storm FPV (Phantom
Thanks guys, i think I'm going to opt for the HUB, i didn't even know it existed. (I know I should learn how to solder, maybe just on something else, don't want to mess up the wiring on my new expensive toy) I hope the HUB is...
Hello!
I finally got my Phantom 2 (non vision) with the gimbal, IOSD mini, and Storm FPV system. I've been flying the P2 by itself (no camera/FPV) for the last few weeks to get used to it and now I'm ready to add on the rest and start getting some footage. I was hoping that i could just plug...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.