Recent content by JAY G

I recently purchased this range extender and there were no instructions. There are a few videos on installation on Youtube but not specific enough for me to follow. Help would be appreciated!

Very goog advice, e4xactly what I was looking for,thank you!!

I need advice on replacing motor on STD 3. One video I watch unsoldered each wire and then of course resoldered. My question is wouldn't it be easier to cut the wires in the middle and splice in the new motor and use shrink tubing to insolate the wires?

I think we are both in the same boat as in tech savvy. I sent the parts in to DJI repair. I was going to attempt soldering myself but got cold feet after reading about there might be more than that connection problem. Turns out It was a good move as there were 2 motor problems that I didn't...

FYI! DJI repaired for $125.00. Now have to wait for return shipping to see the results.

This picture is of a circuit board that the maker says fits all Phantom 3 models. Can anyone verify that this is so?

Bottom left corner just to the right of the screw hole is where the connection goes.

One of the antenna wire connection on the circuit pulled out during crash and can not connect cable. Do you think it could e soldered? This is for a Phantom STD 3!

We maybe related!!

i'M HAVING THE SAME PROBLEM. It seems that the board itself isn't replaceable. Part number for module is P5BBDI22043146 for Phantom 3STD. Let me know what you find and I'll do the same!