FALSE. I tried it on my P3A BEFORE upgraded my camera to 4K and it DOES NOT accept the PRO firmware.
After, I upgraded the camera to the 4K one from the Pro, it accepted the PRO firmware and updated the firmware successfully.
See my thread:
Upgraded my P3A camera to 4K | DJI Phantom Forum
what do you mean? I thought the only difference between the Advance and Pro is the physical camera hardware. Would you elaborate? My Lightbridge is functioning fine without any issues.
just tested it and it flew flawlessly. In the camera setting option, I can now see the options for 4K video quality. Did a few recording while in the air and it looks good on my PC. The upgrade was a success and my drone now is considered a P3P.
Found a broken P3P from local Craigslist for cheap. This kid just had it for 3 days and already crashed it. Drone was broken but camera and gimbal were still in good shape. Had to clean it up a bit and replaced the back plate of the gimbal. Swapped out the 4K camera and I am in the process of...
Found the video. Link for reference:
Didn't know it was that easy to do the swap. I will make sure to do a firmware update on my P3A with the new camera.
Hey guys, I have a P3A and I was able to obtain a broken Phantom 3 Pro with the camera and gimbal still in perfect condition, everything else is badly damage. I want to swap out the P3P camera to my P3A drone. Is there a how-to to remove the camera on the P3?
Thank you in advance.
thanks for ALL your help guys! I figured out the problem. Its the stupid yaw control add-on I got for $2 on Ebay. Took it off and everything works good. I guess the measurement wasn't good enough for that 3D printed model and it was blocking the sticks from going all the way down.
Pics below:
Hi everyone, I have been using the CSC method to start my drone and take it off manually. When I tried to fly it this morning, the drone wasn't responding to my CSC at all. I had to use the "Auto take off" method on my tablet and fly it. No problem at all during the flight.
Did the new update...
Hi everyone, I have been using the CSC method to start my drone and take it off manually. When I tried to fly it this morning, the drone wasn't responding to my CSC at all. I had to use the "Auto take off" method on my tablet and fly it. No problem at all during the flight.
Did the new update...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.