Unable to start the P3A with CSC

[*ice*]

Hi everyone, I have been using the CSC method to start my drone and take it off manually. When I tried to fly it this morning, the drone wasn't responding to my CSC at all. I had to use the "Auto take off" method on my tablet and fly it. No problem at all during the flight.

Did the new update on the GO app cause this to happen? I am using a Nexus 7 2013 wifi only model. Firmware on the RC and P3A are on latest version.

 

[4wd]

It would be worth calibrating the sticks, if it doesn't see the stick as moving to full extent it won't work.
Then again things can be temperamental - it might work normally next day in any case.

 

[F6Rider]

I was also going to suggest calibrating the sticks, this happened to me once and it seemed that the left stick was just a touch out of calibration, don't know why unless it was due to flying too much But a calibration fixed it.

 

[LuvMyTJ]

Be sure and check the search or look at the suggested post at the bottom as you are crafting yours.
Thread closed. Please comment further here - Unable to start the motor with CSC | DJI Phantom Forum