Thank you @quaddamage !!
Mine works fine now:)
For me, the hardest was:
Press ESC to abort autoboot in 1 seconds
Dji-Pro #
In the Re-flashing primary kernel procedure. :p
Great tutorial and thanks for the zip unencrypted images.
Just 1 thing you forget:
In the Re-flashing bootloader Chapter...
Thank you WSCorp65; but as i said on my 1st post:
That's why i think the usb board have an issue and i would try to flash it.
I followed some threads:
https://phantompilots.com/threads/no-luck-flashing-gl300a-p00928-03-usb-board-via-ftdi.136862/...
I tried to flash the usb board with usb-ttl card but i meet some issue in the procedure...
NB:I've already flash the gimbal main board and it works perfectly
But the difference between the two procedures is for the remote, as i understood, i have to decrypt the firmware before flash the board...
Hello,
It's m'y 1st post, i'm a New p3p owner [emoji16]
I just bought a p3p with an issue (i known that)
Actually:
-When i link the Ac to the RC, i have on both of them a green/red blinking led.
-When i connect my Phone, Nothing happen
-When i put a sd (on rc) Nothing happen.
-rc and Ac are...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.