After upgrading both the phantom2 and the RC to the latest firmware it will no longer take off.
I looked at some previous posts and they seemed to recommend calibrating the RC's control sticks. I had already done this as part of the firmware update, but did it again just to make sure...
I updated all the firmware on the P2V itself, but when I open open the RX and hook it up to the software via the microusb cable as shown here:
http://wiki.dji.com/en/index.php/Phanto ... Controller
Nothing happens. I turned the RX off and on, closed and reopened the Assistant Software...
Going back to the original subject for a second, does anybody a video demonstrating connecting the AVL58 wires to the Phantom 2 without the iosd? I want to make sure before I start cutting and soldering cables.
Pardon my noob question, but when in flight the horizons are very hard to get level with my phantom. I'm assuming its because to of the props are scratched and therefore unbalanced, and its not an issue with the camera, right?
Is there a prop balancer that works with the Vision?